Non-Thread Design Pentagon Seat Solenoid Stem/Embed NBR External
Spring Nuclear Core
Detailed Instruction:
| Brand | Voltage | Maximum Pressure (Bar) | Noise | Power (W) | Working type | Armature height |
| BRANDO |
AC/DC
| Normal | Low | AC/DC |
2/2 way normally closed
| 55.8mm |
| Part Number | Tube out diameter | Temperature |
Tube height
| Movable core height | Depth | Certificate |
| BAPC214040065 | 14.0mm | Normal | 40.0mm | 31.7m | 30.6 | VDE&ETL+CETL+CQC |
| Package:With plastic covered to prevent damage and destroy when
delivery.Effectively use the space of standard export
carton,decades items in a carton |
| Delivery:By air ,by sea, by express and other common transportation
are all in available |
After-sale serive:Guarantee every customer resonable requirement And there are exclusively department to discuss with you |
Seal:NBR
Seat:Pentagon Seat wigh thread
Component:Armature tube,pentagon seat and movable core
Primary Material:Stainless steel
Application for dust collector solenoid valve(Assembling with
solenoid coil and solenoid coil housing)
1.The dust collector solenoid valve is a compressed air switch for
the dust removal system of the pulse bag filter. Controlled by the
output signal of the pulse injection controller, the filter bag is
injected one by one and the resistance of the dust collector is
kept within a set range
to clean the dust to ensure the processing capacity and efficiency
of the dust collector
Dust-removing solenoid valve work principle
The diaphragm divides the pulse solenoid valve into two chambers.
When the compressed air is switched on, the compressed air enters
the back chamber through the throttle hole. At this time, the
pressure of the back chamber will press the diaphragm to close the
output port of the valve, and the pulse solenoid valve is in a
"closed" state. The electric signal of the pulse injection
controller makes the armature of the pulse solenoid valve move, the
vent of the back chamber of the valve opens,then the back chamber
loses pressure rapidly and the diaphragm moves backward, the
compressed air is injected through the outlet of the valve, and the
pulse solenoid valve is in the "open" state. The electric signal of
pulse jet control device vanishes and the armature of pulse
solenoid valve is reset. The outlet of the back chamber is closed,
and the pressure of the back chamber rises to make the diaphragm
close to the valve outlet, and the pulse solenoid valve is in the
"closed" state.
Dust-Removing solenoid valve
Aim to give each customers a satisfied result
